MATERIAL SAFETY DATA SHEET
Section I: General Information
|
L&L COATINGS CORPORATION 5102 SANTA FE ROAD TAMPA, FLORIDA 33619 (813) 248-3704 or (813) 248-6723 |
|
DATE: JUNE 1996 |
MSDS CODE |
|
SUPPLIER (IF OTHER THAN MANUFACTURER) |
|||
|
CHEMICAL DESCRIPTION: Block Copolymer/Hydrocarbon Resin |
|||
|
PRODUCT USE: Sealant Tape |
|||
|
PRODUCT NAME(S) AS USED ON LABEL: L&L TRI-CLAD TAPE |
|||
SECTION II: HAZARDOUS COMPONENTS
|
HAZARDOUS COMPONENT |
CAS NUMBER |
NA/UN NUMBER |
APPROX. WEIGHT % |
LD50 or LC50 (species/route) |
SECTION III: PHYSICAL DATA
|
BOILING POINT (F): |
314° (157°C) |
FREEZE POINT (F) |
Not determined |
|
pH |
Not applicable |
VAPOR PRESSURE (mmHg.) |
Not applicable |
|
% VOLATILE (by VOL.) |
None |
SPECIFIC GRAVITY |
1.25 |
|
VAPOR DENSITY |
Not applicable |
EVAPORATION RATE |
Not applicable |
|
SOLUBILITY IN WATER |
Not Soluble |
ODOR THRESHOLD (ppm) |
Not applicable |
|
PHYSICAL STATE |
Gray Tacky |
OIL/WATER COEFFICIENT |
Not applicable |
|
APPEARANCE AND ODOR: Gray tacky tape faced with Polyester, Aluminum, or Tedlar® |
|||
SECTION IV: FIRE & EXPLOSION DATA
|
FLASH POINT (METHOD): None - TCC |
||||
|
AUTO-IGNIT. TEMP.: Not applicable |
LEL: Not applicable |
UEL: Not applicable |
||
|
SENSITIVE TO MECHANICAL IMPACT? No |
TO STATIC DISCHARGE? No |
|||
|
FLAMMABILITY CLASSIFICATION |
Product is not flammable |
|||
|
CONDITIONS OF FLAMMABILITY |
Product is not flammable |
|||
|
EXTINGUISHING MEDIA |
Water, Dry Chemicals, Foam, Carbon Dioxide |
|||
|
SPECIAL FIREFIGHTING PROCEDURES |
Follow normal procedures with self-contained breathing apparatus. |
|||
|
UNUSUAL FIRE AND EXPLOSION HAZARDS |
None known |
|||
|
HAZARDOUS COMBUSTION PRODUCTS |
Carbon Monoxide and Carbon Dioxide |
|||
SECTION V: REACTIVITY DATA
|
STABLE? |
YES XX |
||
|
CONDITIONS OF REACTIVITY: None known |
|||
|
CONDITIONS OF CHEMICAL INSTABILITY: None known |
|||
|
INCOMPATABILITY (MATERIALS TO AVOID): Strong acids or strong oxidizing agents |
|||
|
HAZARDOUS DECOMPOSITION PRODUCTS: Acids, aldehydes, ketones |
|||
|
POLYMERIZATION NO XX |
CONDITIONS UNDER WHICH PRODUCT WILL POLYMERIZE None known |
||
SECTION VI: TOXICOLOGICAL/HEALTH HAZARD DATA
|
ROUTES OF ENTRY |
SKIN CONTACT? YES |
SKIN ABSORPTION? NO |
EYE CONTACT? YES |
INHALATION? YES |
INGESTION? NO |
|||
|
EXPOSURE LIMITS Mineral Spirits Tetrachloroisophthalonitrile Vinyl Acetate |
ACHGIH 100 ppm (TWA) none available 10 ppm (TWA) |
OSHA 100 ppm (TWA) none available 100 ppm (TWA) |
||||||
|
EFFECTS OF ACUTE EXPOSURE Vapor may be irritating to eyes, skin, mucous membrane, respiratory tract. Direct eye contact may cause eye irritation. No evidence of adverse effect if swallowed. |
||||||||
|
EFFECTS OF CHRONIC EXPOSURE Prolonged skin contact may cause temporary reddening of skin |
||||||||
|
SIGNS AND SYMPTOMS OF EXPOSURE Inhalation: headache and nausea in poorly ventilated areas. Eye contact: stinging, redness, and tearing of eyes. Skin contact: temporary reddening of exposed areas. Swallowing: none known |
||||||||
|
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE Respiratory symptoms associated with pre-existing lung disease including (but not limited to) asthma, allergies, bronchitis or emphysema. Proglonged or frequent skin contact may aggravate pre-existing skin conditions such as dermatitis. |
||||||||
|
NAME OF TOXICOLOGICALLY SYNERGISTIC PRODUCTS: None known |
||||||||
|
IRRITANCY OF PRODUCT: Not determined |
||||||||
|
REPRODUCTIVE TOXIN? NO |
TERATOGEN? NO |
MUTAGEN? NO |
SENSITIZER? NO |
|||||
|
CARCINOGENICITY DATA: The NTP has classified tetrachloroisophthalonitrile as a carcinogen. |
||||||||
SECTION VII: PREVENTATIVE MEASURES
|
GLOVES (SPECIFY): Cotton or other protective gloves |
|
|
EYES (SPECIFY): Safety glasses with side-shields or tight fitting goggles |
|
|
FOOTWEAR (SPECIFY): Industrial footwear |
|
|
CLOTHING (SPECIFY): Long sleeves, buttoned collar, long pants extended over shoes or coveralls. |
|
|
RESPIRATOR (SPECIFY): Not needed |
|
|
SPECIFIC ENGINEERING CONTROLS TO BE USED WITH THIS PRODUCT (SPECIFY): Not applicable |
|
|
PROCEEDURES TO FOLLOW IN CASE OF LEAK OR SPILL: Not applicable |
|
|
WASTE DISPOSAL PROCEDURES: Dispose in accordance with local, state and federal regulations |
|
|
HANDLING PROCEDURES AND EQUIPMENT Keep out of reach of children. Wash with soap and water after use and especially before eating, drinking or smoking. |
|
|
STORAGE REQUIREMENTS: Suitable for any general chemical storage area. Store above 40ºF to keep from freezing. |
|
|
D.O.T. SHIP NAME : Non-regulated |
D.O.T. CLASS: Non-regulated |
|
SPECIAL SHIPPING INFORMATION: Keep from freezing |
|
SECTION VIII: FIRST AID PROCEDURES
|
INHALATION: Not applicable |
|
EYE CONTACT: Do not remove. Get Medical attention |
|
SKIN CONTACT: Care should be taken in the removal of the hot melt adhesive. Get medical attention if too sensitive. |
|
INGESTION: Unlikely, but if ingested, it could create a blockage. Get medical attention. |
SECTION IX: PREPARATION INFORMATION
|
PREPARED BY: T. O. Linville |
PHONE: (813)248-6723 |
DATE PREPARED: June 1996 |
|
SOURCES USED: ACGIH ’92; RTECS January 1993; Sax -8th Ed.; Ind. Exposure & Control Techn. For OSHA Regulated Substances, March, 1989; NIOSH Occupational Health Guide for Chemical Substances - Vol. I & II. |
||
